316 stainless steel compact 2-bolt flange bearing

This 2-bolt flanged housing is designed for use in limited space and when there is an existing 2-hole application.

The housing is made of stainless steel (grade 316) which is rustproof and resistant to corrosion from seawater. It is also resistant to all cleaning products and chemicals. The rounded corners and smooth surfaces make these units very easy to clean.

The units are delivered complete with a spherical roller bearing insert that enables the bearing block to carry up to five times more load than conventional bearings. Spherical roller bearings have the advantage that they provide a much larger load capacity than ball bearings and can accommodate axial force.

Many sealing options are possible. Each possesses different properties depending on the application. We would be pleased to advise you on the best choice of seal.

 

 

TypdBCT1H2JLHNGrease holeBasic load ratring
KN for spherical roller bearing
Basic load ratring
KN for double roll ball bearing
Axial movementSeal seat
MetricImperialDynamicStaticDynamicStatic
EXR-02423,8115/1625254454 73  M6596215,74,73,542×7
EXR-0252562/63
EXR-A2525,41
EXR-02828,571 1/830264860 84  M68188165,23,547×7
EXR-030301 2/11
EXR-A3030,161 3/16
EXR-03231,751 1/4352850601179313610,2M688100196,53,552×7
EXR-A3534,91 3/8
EXR-035351 17/45
EXR-03736,511 7/164028516211798??M695105227,53,562×7
EXR-03838,11 1/2
EXR-040401 23/40
EXR-04342,861 11/1645325769 106  M610012022,98,1462×7
EXR-04444,451 3/4
EXR-045451 3/4
EXR-04949,21 15/1650346073 114  M6120140259,6472×7
EXR-050501 31/32
EXR-05150,82

 

Footnotes: T¹ The dimension T gets a maximum 6 millimetres wider when the bearing unit is assembled with centrifugal seals.

Load directions for Extreme Bearings

Extreme Bearing units are intended for loads acting vertically towards the base plate support. Therefore, if the bearing housing is supported over its entire base, loads are limited only by the load limits of the bearing insert. If loads acting in other directions occur or if the housing is not supported over its entire base area, check that the magnitude of the load is permissible for the bolt assembly attached to the machine frame.

The EXW housing (left) has a more elongated shape in comparison
to the more compact EXR (right) housing.